What are the considerations for the operation of rubber joints?

The main function of rubber joints is to absorb vibration and displacement, reduce noise and decrease vibration. The material of rubber joints is mainly rubber, which has good heat resistance, oil resistance, acid and alkali resistance and other liquid media, can withstand temperature changes, and has good anti-aging properties and UV resistance. It is made of multi-layer vulcanized rubber. The ability of acid and alkali resistance is very strong corrosion resistance. Corrosion resistance and oil resistance are available in acidic or alkaline media. It usually has good corrosion resistance.
When installing, the inner and outer surface of the rubber joint should be checked first to make sure there is no damage or wear, then check whether the material of the rubber joint meets the standard. When installing, care should be taken to avoid the installation position being too high, resulting in excessive pressure and deformation of the rubber joint, causing pipeline displacement. If it is not allowed, it should be adjusted until it is fully recovered. If the installation position of rubber joint is too high or too low will make the rubber joint bear too much pressure; if it exceeds its allowable pressure value, it will lead to rupture; if there is an error in the design size of rubber joint, too much pressure will lead to pipe bending and deformation is also one of the reasons. Therefore, reasonable adjustment should be made in the design according to the specific situation. Pipeline deviation, reduce vibration, reduce displacement, and reduce the cost.
During use, attention should be paid to temperature changes, when the temperature is higher than 70 degrees, the use of high temperature must stop the rubber joint connection part into the room and timely adjustment and adjustment; if there is a breakage, must be replaced. Must maintain a good state of use. Only in this way can we ensure the normal operation of rubber joints under various working conditions. When installing, the verticality of the joint and the pipe must be ensured, and if there is any deviation, it should be corrected immediately. Otherwise, it will affect the service life and stability of the product; in operation, it may encounter environmental changes such as high temperature causing deformation and damage to the rubber joint.