EPDM rubber joints are selected according to your needs

The EPDM rubber joints are polished and colored to give the wall a consistent color and reflectivity. In order to avoid grease, the exposed part of the large area of the EPDM rubber joint is installed in a thick sandwich consisting of galvanized sheet and compacted sheet. The polished EPDM rubber joint is fixed with the galvanized steel plate by using epoxy resin as binder. The floating part on the thin plate of the EPDM rubber joint is punched by using positive and negative molds. EPDM rubber joint not only has a long service life, but also is a good material for making the convex structure, which can strengthen the beauty of the building, so it is often the primary symbol of the square. Different levels of exterior finish also supply a selection scale for a variety of different construction facilities to meet actual needs.
 
Before application, it is necessary to carry out an exhaustive inspection of the plate for defects and complete cleaning treatment and passivation treatment. When the chloride is not completely flushed out, do not start to prevent stress corrosion cracking. When planning chemical containers, they should not be considered for holding seawater because this will lead to the risk of crevice corrosion. In this case, EPDM rubber joints may occur difficult to remove limestone deposits. In coastal and harbor areas, many foreign clumps and silt enter the condenser piping, which is especially simple to form serious obstacles, and it is necessary to adopt methods to remove such conditions. A reasonable method is to use the rubber ball to circulate through the pipe, because the rubber ball can have a kneading effect and then clean up the pipe wall.