Structural design of welded corrugated compensator

Structural design of welded corrugated compensator
If we spray and descaling welded corrugated compensator processing, it not only to completely remove dirt, rust and oxides, but also produce rough friction and impact. Average degree. For the processing head, the outer layer of the steel is cleaned with emulsions and solvents. This removes dirt, grease and smoothing agents, but does not completely weld the outer surface of the steel. Polish one of the layers with an item such as a steel warp brush. If iron oxide is attached to the surface of the steel, we can use these to remove some weld slag, rust and scale.
This method is particularly practical if it is more robust. Welded corrugated compensators are processed with both electrolytic and chemical pickling methods. We can use this pickling to remove daily coatings, rust and scale. Although we use this chemical cleaning method to achieve good surface cleanliness and roughness, the anchor pattern is relatively shallow and more likely to be contaminated.
If we spray and descale the welded corrugated compensator process, it not only to completely remove dirt, rust and oxides, it will also produce roughness with friction and impact. Average degree. When operating the welded corrugated compensator processing content, in order to make all parts of the welded corrugated compensator after processing perform very well.
It is very important to continuously strengthen the quality of welded corrugated compensator in the processing process. From the relevant processing content, it is not negligible to achieve a stable state of the welded corrugated compensator in terms of high temperature resistance, corrosion resistance and other related properties. And in the process, from the long-term use of welded corrugated compensator, attention should be paid to ensure the service life.