-
Material and Connection of Telescopic Dismantling Joint
Telescopic dismantling joint is one of the most commonly connector used in pipeline protection. Gongyi LuoYing Pipeline Equipment Company is specialized in telesc
-
How to Set up the Stents When Installing Double-flange Limited Expansion Joint
Double flange expansion joint has strict rule, when installing, should pay attention to the setup and stress of the fixed stents; it must be designed and instal
-
Difference between Hard Seal Butterfly Valve and Soft Sealing Butterfly Valve
Hard seal butterfly valve:
Sealing pair are on both sides of the metal material or hard other material referred to as the "hard seal". The seal of the seal perf -
Service Life and Aging of Flexible Rubber Joint
Aging of Flexible Rubber Joint
-
How to Install Rubber Expansion Joint to Make It not Leaking
How to Install Rubber Expansion Joint to Make It not Leaking
-
Brief Introduction of Rubber Duckbill Check Valve
Brief Introduction of Rubber Duckbill Check Valve Duck mouth check valves made in our company have been constanly receiving reputation not only at home but over
-
Double Arch Rubber Exppansion Joint
Double Arch Rubber Exppansion Joint Information
-
XHS Hanger Mount
XHS Hanger Mount is designed with low frequency value with spray treatment,thus it's of good weatherability and good shockproof effect. The spring mount is cov
-
Research and Development of PTFE Lining Rubber Joint
Development of rubber joint has decades of history, and as the environment changes, requirements for rubber expansion joints are also getting higher and higher
-
Common Types of Axial Bellows Compensator
Bellows compensator is also called bellows expansion joints and telescopic joint. It composes of bellows, end tubes, brackets, flanges, guide tube and other acc
-
How to Judge the Quality of Flexible Rubber Joint
How to judge the quality of flexible rubber joint
-
The Installation of Bellows Compensator Transportation Work
Bellows compensator can also be called the expansion joint, expansion joints, he is a kind of installed on two pipes in the middle of the pipe fittings, pipe an
