What are the advantageous features of the special rubber joint for water supply pipes?

Special rubber joint for connecting pipeline is a new product for connecting mechanical equipment such as pump, gate valve, pipeline and pipeline. According to the full ground bolt connection, the whole offset, easy to install. It can bear the radial working pressure of the pipeline. Therefore, during installation and maintenance, it can be adjusted according to the actual installation specifications. In the operation process, it not only improves the efficiency, but also protects the pipeline mechanical equipment such as pumps and valves. One side electric welding. Rubber joints for connecting pipes are divided into 0.6Mpa, 1.0Mpa, 1.6Mpa, 2.5Mpa, 4.0Mpa, etc. according to pressure. It can also be made uniquely according to the requirements. When installing the rubber joint for connecting pipelines, both sides of the commodity or the assembled length should be adjusted, the top angle should be tightened evenly, and then the positioning nut should be adjusted so that the pipeline can be expanded and contracted arbitrarily within the range of collection and release, and the expansion amount should be locked to ensure the reliable operation of the pipeline.
Single rubber joint is suitable for even connection on both sides. When installing, adjust the connection length of both sides of the commodity. Tighten the valve cover foot bolt symmetrically at the top angle, and then adjust the positioning nut so that the pipe can be expanded and contracted arbitrarily within the range of retracting and releasing, locking the expansion amount and ensuring the reliable operation of the pipe. Applicable to both sides of the uniformly connected pipeline, the installation of adjusting both sides of the commodity and its assembly length, the top angle set capital symmetrically tighten the valve cover foot bolt, so that the whole, and a certain amount of offset, easy to install and maintain, according to the site specifications to adjust. Anti-radial driving force can be transferred to all pipelines during operation. The working pressure driving force (blind force) can be reduced to compensate for pipeline installation deviation, and a single rubber joint cannot absorb radial offset.
 
The method of deformation of rubber joints is to regulate the installation deviation of pipelines to prevent damage to all normal functions of rubber joints, shorten the service life and improve the load of pipelines, mechanical equipment and supporting prefabricated components. When installing a single set of specification rubber joint, both sides of the commodity or the assembly length should be adjusted, the top corner should be tightened evenly, and then the positioning nut should be adjusted so that the pipeline can be expanded and contracted arbitrarily within the range of the collection and release amount, locking the expansion and contraction amount to ensure the reliable operation of the pipeline.