Suggestions of raw materials for the clamp type rubber soft joints used in pipelines according to di

Due to the higher material cost than ordinary rubber, clamp type rubber soft joints are higher than ordinary rubber soft joints. While using rubber soft joints, customers must choose raw materials according to the application material. This can avoid the early damage of the product and the weakening of the use effect. After the vulcanized rubber is formed, it consists of metal material flange or parallel surface connector loosely sleeve. Clamp type rubber soft joints are selected to replace flanges and bolts to achieve the purpose of compensating the offset formed by water transmission due to thermal expansion and contraction of the pipeline. The use of clamp type rubber soft joint: applied to low temperature heating system, need to reach the pipeline expansion, technical requirements. Used in fire-fighting system, daily life water supply and drainage system, boiling water system, air conditioning unit, etc.
When the oil feed and oil discharge pipe is installed on the clamp type rubber soft joint, the pipe should not be lower than the oil feed and oil discharge specifications of the pipe. The oil inlet pipe should not be too long and the elbow should not be too much, otherwise it will affect the regular operation of the clamp type rubber soft joint.
The installation method and the connection method of different rubber soft joints are also different, so we have to select the right clamp rubber soft joint according to the specific application environment. The clamped rubber joint belongs to a kind of rubber joint, and the clamped rubber joint is made by replacing the flange and bolt with a clamp. When the bolts are on, first tighten the symmetrical bolts, six or four, to ensure that the ball is in place on the flange.