Frequently asked questions about rubber pipe joints and how to install them

The new products for connecting facilities such as pipes with pipelines are connected to each other according to full screws, making them integral with certain deviations and easy installation. It can withstand the radial working pressure of the pipeline. In this way, the installation and maintenance process can be adjusted according to the site installation specifications. In the operation process, it not only improves the working capacity, but also has a certain protective effect on the valve and other pipeline machinery and equipment. How to properly install rubber pipe joints, which should be a headache for many customers, we are here to briefly talk about the proper way to install rubber pipe joints and common problems.
1 . All normal common substances of rubber pipe joints are water with a general temperature of 0-60℃. When oil, strong acid, strong alkali, high temperature, corrosive and firm texture, the corresponding special durable raw material rubber pipe joints should be used, and shall not blindly follow the trend or common.
2 . The flange connecting the rubber pipe joint should be flange or flange conforming to the requirements of GB/T915.1(RF).
3 . When the pipeline material is strong acid, strong alkali, oil, high temperature, etc., the automobile blocking connector should be used higher than the pipeline pressure. When rubber pipeline connector is applied to water import and export trade, it should be located near the water side, and the metal material reducer connector should be installed in the middle of water and installed at the large diameter of the large and small head.
4 . When the pipeline offset is large, the number of connectors should be increased to parallel surface offset. In order to better adjust the pipeline deviation, so that the connectors are in extreme disturbance offset and error, not to mention exceeding the degree (expansion, deflection, offset, etc.).
5 . When draining high-rise residential drains or hanging in the air drains, the pipes should be fixed on the bracket. Fixed bracket or anchor frame, the connector shall not bear the net weight and axial force of the pipe itself, otherwise the connector shall be equipped with anti-pulling equipment (its bearing capacity must exceed the axial force of the pipe).