Pressure of luoying rubber joints

Pressure of luoying rubber joints
The pressure of bendable rubber joints refers to the high working pressure that rubber joints can bear during operation, which contains the working pressure of gases, air compression, water, sea surface, boiling water, oil, acid, alkali and other liquids passing through the pipeline.
The usual working pressure of rubber joints are 1.0MPa, 1.6MPa, these two pressures are used a lot, of course, the working pressure of rubber joints includes but is not limited to these two, because it also has 0.25MPa, 0.6MPa, 1.0MPa, 1.6MPa, 2.5MPa, 4.0MPa, 6.4MPa. the latter two are high pressure, the general manufacturers can not produce high pressure Rubber soft joints, our company as a professional manufacturer of rubber soft joints, strong technical force, experienced, with decades of rubber soft joint manufacturing history, can produce a variety of high-pressure rubber soft joints and other pipe fittings.
The bursting pressure of rubber soft joints means that the rubber soft joints may burst, tear and be damaged under this pressure, so the pipeline pressure is required and cannot exceed the bursting pressure.
It should be selected according to the pressure of the pump and pipeline, and must correspond to or be greater than the working pressure of the pipeline and equipment. You cannot use a small pressure rubber joint to install in a large pressure pipeline, which will cause damage to the rubber joint and pipeline equipment.
To know the working pressure of rubber joints, you can look at the package, which will be clearly marked, and there is also a pressure mark on the main body of the rubber joint, and then, you can see the thickness of the flange, if the flange is thin, the working pressure of the rubber joint will be smaller, and vice versa, the pressure is larger.