-
KXT nitrile rubber bendable rubber joint actual operation
KXT buna NBR bendable rubber joints made with relatively low average molecular weight have a better oleophobic appearance, which is more conducive to demoulding
-
What is the basis for the selection of the grooved wear-resistant rubber joint?
In all welding applications of grooved wear-resistant rubber joints, the edges of the grooved wear-resistant rubber joints are melted, and when the clamping bra
-
Buckle slot EPDM EPDM rubber flexible connection production process
Generally speaking, the grooved EPDM EPDM rubber joint will try to reduce this error as much as possible, but in practice, it is very difficult to reach an erro
-
Reasons for non-smooth surface of plate-and-box type corrugated compensator
The plate-and-box corrugated compensator is planned for deep-sea, high-temperature, high-pressure use. Its higher strength means that it can have thinner walls,
-
Transverse rod corrugated compensator different material characteristics
On the acceptance of fluid pressure of the transverse rod corrugated compensator are to carry out hydraulic pressure test to check its pressure resistance and q
-
What are the characteristics and production process of hinged corrugated compensator
The hinged corrugated compensator can be passivated with oxidizing agents, forming a layer of tough and fine chromium-rich oxide maintenance film Dr2O3 on the e
-
What are the main properties of the bend pressure-balanced corrugated compensator?
The general choice of three-electrode torch argon arc welding, bend pressure balance corrugated compensator wall thickness S ≥ 2mm, welding speed than a sing
-
JDX NBR bendable rubber joint storage advice
The width of JDX NBR bendable rubber joint becomes narrower and the arc pit becomes longer, narrower and deeper. the residual height of JDX NBR bendable rubber
-
Do rubber expansion joints under DN300 need to be fixed with fixed brackets?
In DN300 or below, the pipeline already has a fixed bracket on the premise, to be able to not need to install anti-pull off equipment. In DN300 rubber expansion
-
About the application of bellows expansion joints in heating engineering
As a compensation element with good compensation performance and easy maintenance, bellows expansion joints have been more and more widely used in domestic and
-
What are the main structural materials of flexural rubber joints?
The flange flexural rubber joint is strictly over-shifted and installed during the installation process. The actual axial displacement pressure of the rubber jo
-
Rubber Gaskets Details
Rubber gasket has the characteristics of high temperature resistance, low temperature resistance, ozone resistance, aging resistance, corrosion resistance, oil
